Automation and Dispatch

Published: 11 May 2020
Category: Services

System of automation and dispatching of resource allocation points

The system provides increased safety of energy supply, reliability of equipment operation, reduced risk of accidents and anticipation of critical situations dangerous to human life and health.

The developed automation and dispatching system has been under commercial operation for more than 18 years.

More than 20 years of experience in the construction of autonomous power supply systems was used by our specialists to draw up options for hydraulic fracturing automation using batteries:

Power supply of hydraulic fracturing telemetry with backup from 1 to 2 months using AGM Gel battery (low cost, poor frost resistance, high mass, charge 10 hours).
Power supply of hydraulic fracturing telemetry from 1 to 12 months using LiFePo4 battery (high cost, frost resistance, fast charge 3 hours).
Autonomous power supply of hydraulic fracturing from solar panels with backup energy in the battery.

Monitored parameters:

Inlet and outlet pressure

Gas temperature, room temperature

Safety shutoff valve position

Door opening

Gas contamination concentration CH

Supply voltage, battery voltage

Advantages and scope

The hydraulic fracturing automation and telemetry system is designed to control hydraulic fracturing operation parameters and prompt response in case of emergency situations (parameters go beyond the set values).

The specialists of the service and technical support department in real time monitor the readings and parameters of gas metering stations, hydraulic fracturing, gas distribution stations equipped with gas correctors of various manufacturers using a single control and monitoring system.

Online parameter control
AGRP-2.120 telemetry system allows monitoring parameters with data accumulation with various time intervals, up to the on-line mode.
Work in all weather conditions
The use of special frost-resistant LiFePO4 batteries allows you to operate the system at temperatures below -30 ºC, without significantly reducing (degrading) the battery capacity.
Prompt service
The LiFePO4 battery charge takes no more than 3 hours (routine maintenance work on hydraulic fracturing). The low weight of the battery makes replacement easy. work can be done by 1 person.

You can familiarize yourself with the detailed table of parameters of hydraulic fracturing automation systems, depending on the required set of parameters and sensors, by downloading a PDF brochure with a description of the products, systems and software services of Rustechnology LLC.